PHYSICAL ABILITY TEST
This administrated test will measure physical performance through a series of exercises. Scoring will be on a pass/fail basis.
The physical ability test will consist of the following:
The purpose of this test is to determine the muscular strength in your dominant hand.
You will use your dominant hand to complete three trials of the test.
You will place the dynamometer in your dominant hand with the rounded edge against the base of your hand.
Make sure your thumb touches or overlaps with your first finger.
You will stand with your arm at your side and your elbow bent to 90 degrees.
You will squeeze the dynamometer as you lower it downwards towards your hip.
When the dynamometer is next to your hip, stop squeezing.
You will be completing one practice trial with your dominant hand at a 50% effort. This will be followed by 3 test trials with the dominant hand where you will exert maximum force.
You will receive a 30-second rest between each set of trials.
When you have completed the test, the test administrator will take the dynamometer from you.
The purpose of this test is to evaluate your abdominal strength.
You will lie down on your back with your knees flexed to a 45 to 60 degree angle, feet flat on the floor, and your heels placed about 12 to 18 inches from your buttocks. Your feet will be held by another candidate or a test administrator.
You will cross your arms over your chest, with your hands placed on the opposite shoulders near your collarbone. In this position, your fingers should touch the top of your shoulders. Your arms must maintain contact with your chest at all times.
With each sit-up, you must curl your shoulders, keeping your lower back on the ground until you have curled the upper back, and finally come to a position in which your elbows touch your thighs. Make sure you curl your back, as this will force you to use your abdominal muscles and keep you from straining your back. Lie back down until your mid-back touches the mat surface, then curl up until your elbows touch your thighs to complete another sit-up.
You will perform as many sit-ups as possible within a 60-second time period. You will be told when 30 and 15 seconds are left.
Guidelines for Sit-Ups
Be careful to perform the sit-ups in the proper manner. The administrator will tell you when your sit-ups are incorrect.
You will do as many sit-ups as possible within a one (1) minute time period. You will be told when there are 30 and 15 seconds remaining.
A sit-up will not count if:
Your arms are not in contact with the chest
Your elbows do not contact the thighs
You do not return to a supine position with the mid-back touching the testing surface
Your hips/buttocks do not remain in contact with the floor
Your fingers are not on opposite shoulders
If you perform an incorrect sit-up, the administrator will provide a short command to inform you of the error.
Only properly performed sit-ups will count. You may rest between sit-ups, but the stopwatch will not be stopped.
Your score will be the number of properly performed sit-ups that you complete in one (1) minute. Attempt to complete AS MANY SIT-UPS AS YOU CAN.
The purpose of this test is to evaluate your upper body strength.
Your starting position requires that only your feet and hands be in contact with the testing surface. Your feet must be 8 to 12 inches apart and your hands placed slightly wider than shoulder width apart. Also, your arms must be extended and straight in the starting position.
Your legs, buttocks, back, and shoulders must be in a straight alignment.
To complete a push-up, bend the elbows and lower your torso until the elbows are flexed at a 90-degree angle. Once the elbows are flexed at a 90-degree angle, return to the starting position by straightening your elbows.
Your arms must reach a 90 degree angle with the back of your upper arm even with your back. To ensure you have reached a 90 degree angle a foam block will be used. The foam block is placed directly under your chest. Your chest must touch the foam block when you lower yourself to perform each push-up.
When completing the push-ups, your legs, buttocks, back, and shoulders must remain in a straight alignment.
Once you touch the foam block with your chest, return to the correct starting position.
You are to do as many push-ups as possible within a one (1) minute time period. You will be told when there are 30 and 15 seconds remaining. You will be given only one opportunity to do this push-up event.
Guidelines for Push-Ups
A push-up will not count if:
You do not lower to a 90-degree or more angle and touch the foam block
Your knees come in contact with the test surface
Your legs, buttocks, back, or shoulders do not remain in a straight alignment
You do not return to the starting position with arms fully extended
If you perform an incorrect push-up, the administrator will provide a short command to inform you of the error.
Only properly performed push-ups will count. You may rest between push-ups in the “up position,” but the stopwatch will not be stopped.
Your score will be the number of properly performed push-ups that you complete in one (1) minute. Attempt to complete AS MANY PUSH-UPS AS YOU CAN.
The purpose of this test is to climb over a 5-foot wall and run as fast as possible through a short distance course that has changes of direction.
You will begin this test by standing behind the starting line.
On the command “GO” run to the wall, climb over the wall, and continue running through the course to the finish line (See diagram below).
Follow the outline of the course. To start, run straight ahead 15 feet, climb over the wall, run to the far cone, turn around the cone, and then run back to the first cone in the middle.
Continue through the course weaving in and out through the center cones. Run around the top cone. Then weave back through these same cones. Turn right and run up to the cone up on the left and back down past the cone at the finish line.
Guidelines for Wall Agility Run
An administrator will walk you through the course prior to beginning the test.
You will complete two trials of the Wall Agility Run. Perform both trials as quickly as possible.
If you trip, stumble or fall, continue to run. If you miss a turn around a cone or displace a cone during either trial, the test will be stopped. You will be given a rest before the retest. If you miss a turn or displace a cone on the retest, you will not receive a score for that trial.
If you cannot get over the wall on the 1st attempt during a trial, go back to the starting line and make a 2nd attempt. If you are unable to climb over the wall, you will not receive a score for that trial.
Based on the chart shown below, you will earn test points related to the dynamometer score, sit-ups, and push-ups that you perform in the given period of time, and the time it takes you to complete the Wall Agility Run. You must attain at least 1 point on each event. If you fail to achieve 1 point on an event, you will not pass the event, and you will not advance to subsequent events.
The points that you earn across the four events will be summed. To pass the overall Physical Ability Test, you must earn a total of 20 points across the four events, and achieve at least 1 point on each event.
Have Questions? Contact the San Francisco Police Department Recruitment Unit
1245 3rd Street, 5th Floor
San Francisco, CA 94158
Phone: 1-415-837-7270
Email: JoinSFPD@sfgov.org